D-Link DES-3528 - xStack Switch - Stackable User Manual - Snmp Host Table
xStack DES-3528 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
53
SNMP Host Table
Use the SNMP Host Table window to set up SNMP trap recipients. To configure SNMP Host Table entries, click
Configuration > SNMP Settings > SNMP Host Table:
Figure 6- 34. SNMP Host Table
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP host
for the Switch.
User-based Security
Model
SNMPv1 - Specifies that SNMP version 1 will be used.
SNMPV2c - Specifies that SNMP version 2 will be used.
SNMPV3 - To specify that the SNMP version 3 will be used.
Security Level
NoAuthNoPriv – To specify a NoAuthNoPriv security level.
AuthNoPriv - To specify an AuthNoPriv security level.
AuthPriv - To specify an AuthPriv security level.
Community String/
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
To implement your new settings, click Apply.
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string used to
identify the SNMP engine on the Switch. To display the Switch's SNMP Engine ID, click Configuration > SNMP
Settings > SNMP Engine ID:
Figure 6- 35. SNMP Engine ID Configuration window
To change the Engine ID, type the new Engine ID in the space provided and click the Apply button.