EDAN F6 User manual - Chapter 12 After Monitoring

F Series Fetal & Maternal Monitor User Manual                                 After Monitoring 

- 129 - 

Chapter 12 After Monitoring 

12.1 Completing Monitoring 

After monitoring, 

1)  Remove transducers or electrodes from the patient; wipe the remaining gel off the 

patient and the transducer with a clean soft cloth or tissue. 

2)  Press the PRINT key to stop printing, and press the paper advancing key 

 to 

advance the paper. 

3)  Wait the paper to stop and then tear it off along the perforation. 

NOTE:

After the fetus is delivered in the labor, the monitor may pick up signals of the umbilical 

cord and display a trace/numeric. To avoid misinterpretation, it is recommended to 

remove the transducers from the patient and switch off the monitor immediately after the 

fetus is delivered. 

12.2 Switching Off 

1)  Press and hold the POWER switch for at least 3 seconds to switch off the monitor. 

2)  Unplug the power cord. 

CAUTION

Do not press the POWER switch continuously. Allow at least 10 seconds between 

switching the monitor on and off.