EDAN F6 User manual - 5.2 Printing Configuration

F Series Fetal & Maternal Monitor User Manual                                         Printing 

- 41 - 

5.2 Printing Configuration 

NOTE:

All the parameters should be well configured before printing starts. You can not change 

the configuration in the process of printing. 

5.2.1 Switching Auto Start Printing On or Off 

You can switch auto start printing on or off: 

1 Select the setup key 

  on the main interface. 

2 Select Start Monitoring > PRINT. 

3 Select ON or OFF (default). 

4 Select OK. 

5.2.2 *Choosing the Paper Speed 

You can choose a paper speed of 1 cm/min, 2cm/min or 3cm/min: 

1 Select the setup key 

  on the main interface. 

2 Select Recorder > Print Speed. 

3 Select 1 cm/min, 2 cm/min or 3 cm/min (default). 

4 Select OK. 

NOTE:

Different paper speed setting causes different FHR trace appearance on the record 

paper. To avoid misinterpretation, we recommend you to set all monitors in your 

institution to the same paper speed. 

5.2.3 *Changing the Print Timer 

You can choose different time lengths for the print timer: 

1 Select the setup key 

  on the main interface. 

2 Select Recorder > Timer. 

3 Set timer to 10 ~ 90 (minutes, the step is 5) or Infinite (default). For a fixed time, the 

recorder stops when the time is up. For Infinite, there is no time limit. Whatever the setting 

is, the recorder stops when this patient’s traces come to the end or if the PRINT key is 

pressed in midway. 

4 Select OK.