EDAN F6 User manual - 6.5 Setting Date and Time

F Series Fetal & Maternal Monitor User Manual                       Pre-Monitoring Preparation 

- 49 - 

6.5 Setting Date and Time 

You can change the date and time of the monitor, 

1 Select the setup key 

  on the main interface. 

2 Select Date And Time. 

3 Set the year, month, date, hour, minute and second. The first three numbers are used to set 

the year, month and date. Their orders vary with the preset Date Format below. 

4 Select Date Format for the format of the date; there are three options: yyyy-mm-dd 

(default), mm/dd/yyyy and dd/mm/yyyy. 

5 Select OK. 

CAUTION

You should set date and time information in advance. After this information is changed, 

the monitor starts new monitoring with an auto ID. Therefore, we advise you to restart 

the monitor after changing date or time information, and do not perform this operation 

when monitoring is in process. 

NOTE:

The date and time remain in the monitor for at least two months after it is switched off. 

You do not have to set date and time before monitoring each time. 

6.6 Connecting Transducers 

Check for visible damages of the transducers every time before connecting them to the monitor. 

Pay special attention to the cracks on the transducers and cables before immersing them into 

conductive fluid. If damage is found, replace them with good ones at once.