Maestro e200 series User Manual - page 103
MAESTRO WIRELESS SOLUTIONS
| NETWORK
E200 SERIES | USER MANUAL VERSION 1.0
http://support.maestro-wireless.com
103
Parameters
Description
Bring up on boot
Allows the WAN interface to be live after every
reboot.
Bring up on boot for WAN interface is checked by
default.
Use builtin IPv6 -
management
Allows to use the built in IPv6 management
configuration.
Use broadcast flag
Check to use the broadcast flag.
This flag is generally used by the ISP’s.
Use default gateway
Click to configure a default gateway route.
None of the gateway routes are configured by
default.
Use DNS server
advertised by peer
Allows advertising the DNS server address.
Use DNS server advertised by peer for WAN
interface is checked by default.
If unchecked, the advertised DNS server addresses
are ignored.
Use gateway metric
Enter the gateway metric. It ensures a separate
routing entry for the respective interface in the
main routing table.
The default metric is 3.
Client ID to send
when requesting
DHCP
Enter the Client ID that shall be sent when
requesting DHCP.
Vendor Class to send
when requesting
DHCP
To allocate DHCP IP Addresses based on Vendor
Class.
Override MAC
address
Click to override the default MAC Address for the
WAN Interface.
On factory reset, it will be set to default MAC
address.
Overrride MTU
Click to override the default MTU value (Maximum
Transmission Unit)
The default MTU is 1500.
Table 11.1-13: Advanced Configurations of WAN Interface