Maestro e200 series User Manual - page 108
MAESTRO WIRELESS SOLUTIONS |
NETWORK
E200 SERIES | USER MANUAL VERSION 1.0
http://support.maestro-wireless.com
108
Parameters
Description
Bring up on boot
Allows the WAN interface to be live after every reboot.
Bring up on boot for WAN interface is checked by
default.
Use builtin IPv6 -
management
Allows to use the built in IPv6 management
configuration.
Use broadcast flag
Check to use the broadcast flag.
This flag is generally used by the ISP’s.
Use default gateway
Click to configure a default gateway route.
None of the gateway routes are configured by default.
Use gateway metric
Enter the gateway metric.
The default metric is 3.
Use DNS server
advertised by peer
Allows advertising the DNS server address.
Use DNS server advertised by peer for PPTP interface
is checked by default.
Client ID to send when
requesting DHCP
Enter the Client ID that shall be sent when requesting
DHCP.
Vendor Class to send
when requesting DHCP
To allocate DHCP IP Addresses based on Vendor
Class.
Inactivity timeout
This is time the router should wait before sending an
echo request to check whether the link is alive or not.
The LCP echo interval by default is 20 seconds.
Overrride MTU
The Router will wait for the LCP echo request
response for the LCP Echo interval defined after every
attempt. It declares LCP link as closed if it does not
receive response after this defined period of attempts
Use 0 seconds to persist the connection.
Table 11.1-17: Advanced Configurations for PPTP