Maestro e200 series User Manual - page 122
MAESTRO WIRELESS SOLUTIONS |
NETWORK
E200 SERIES | USER MANUAL VERSION 1.0
http://support.maestro-wireless.com
122
Parameters
Description
Bring up on boot
Allows the WAN interface to be live after every reboot.
Bring up on boot for WAN interface is checked by
default.
Use builtin IPv6 -
management
Allows to use the built in IPv6 management
configuration.
Use broadcast flag
Check to use the broadcast flag.
This flag is generally used by the ISP’s.
Use default gateway
Click to configure a default gateway route.
None of the gateway routes are configured by default.
Use DNS server
advertised by peer
Allows to advertise the DNS server address.
Use DNS server advertised by peer for WAN interface
is checked by default.
If unchecked, the advertised DNS server addresses
are ignored.
Use gateway metric
Enter the gateway metric.
The Load Balancer uses these Metric values to
determine priority of a WAN.
The default metric is 4.
Client ID to send
when requesting
DHCP
Enter the Client ID that shall be sent when requesting
DHCP.
Vendor Class to
send when
requesting DHCP
To allocate DHCP IP Addresses based on Vendor
Class.
Override MAC
address
Click to override the default MAC Address for the WAN
Interface.
On factory reset, it will be set to default MAC address.
Overrride MTU
Click to override the default MTU value (Maximum
Transmission Unit)
The default MTU is 1500.
Table 11.1-27: Advanced Configuration for WWAN Interface