Maestro e200 series User Manual - page 91
MAESTRO WIRELESS SOLUTIONS
| NETWORK
E200 SERIES | USER MANUAL VERSION 1.0
http://support.maestro-wireless.com
91
Parameters
Description
Bring up on boot
Allows the 3G interface to be live after every reboot.
Bring up on boot for 3G interface is checked by
default.
Use builtin IPv6 -
management
Allows to use the built in IPv6 management
configuration.
Enable IPv6
negotiation on PPP link
Click to enable IPv6 negotiation on PPP link.
Modem init timeout
Enter the maximum wait time in seconds for the
modem to become ready.
The default modem initiation timeout 20 seconds.
Use default gateway
Click to configure a default gateway route.
None of the gateway routes are configured by default.
Use gateway metric
Enter the gateway metric.
The default metric is 5.
Use DNS server
advertised by peer
Allows the router to advertise the DNS server address.
Use DNS server advertised by peer for 3G interface is
checked by default.
LCP echo failure
threshold
Presume peer to be dead after configured LCP echo
failures. Use 0 to ignore failures
LCP echo interval
This is time the router should wait before sending an
echo request to check whether the link is alive or not.
The LCP echo interval by default is 20 seconds.
Inactivity timeout
The Router will wait for the LCP echo request
response for the LCP Echo interval defined after every
attempt. It declares LCP link as closed if it does not
receive response after this defined period of attempts
Use 0 seconds to persist the connection.
Table 11.1-4: Advanced Configurations for 3G Interface