Maestro e200 series User Manual - page 136
MAESTRO WIRELESS SOLUTIONS |
NETWORK
E200 SERIES | USER MANUAL VERSION 1.0
http://support.maestro-wireless.com
136
Parameters
Description
Enabled
Enable the Interface.
No –
Interface do not participate in Load
Balancing.
Yes –
Interface is enabled and can connect to
Internet. Once enabled it can be tracked using
ping configuration.
Tracking IP
IP Address to which the ping request are sent from the
interface to determine if the interface is up or down.
Leave the textbox blank to assume the interface is always
online.
Tracking reliability
Enter the number of response that must be received from
tracking IP Addresses to consider the Interface as up.
Ping count
Enter the number of ping packets that will be sent.
The default ping count is 1.
Ping timeout
Enter the time to wait for a response to ping request sent
before declaring the interface unreachable. The wait time is
in seconds.
The default timeout is 2 seconds.
Ping interval
Specifies the time in seconds between sending ping packets.
The default ping interval is 5 seconds.
Interface down
The no. of consecutive failed attempts after which the
interface is declared down.
The default value for failed attempts is 3.
Interface up
The no. of consecutive successful attempts after which the
interface to determine the reliability of the network
connection through the interface.
The default value for successful attempts is 3.
Metric
Enter the Interface Metric.
The route with least metric is considered as best route.
The default metric assigned to the interface is 1.
For load balancing between two interfaces, both the
interface must have the same metric value on the Member
Configuration page.
Table 11.2-4: Modify MWAN Interface