Pacific Communications SmartIP-16PD User Manual - page 43
Part 3 - Configuration
43
Types of configuration options shown vary
depending on the PTZ functions supported by the
camera.
1
2
3
4
5
6
7
8
9
0
Numbers shown below Preset, Scan, Pattern,
and Tour indicate the numbers of configured
functions.
1 Preset
s Use the buttons below to choose a preset
position.
- Directional Buttons (
):
Used to tilt and pan the camera.
- Zoom (
): Zoom in and out.
- Focus (
): Adjust camera focus to far
or near.
- Speed: Specify the camera's panning and
tilting speed.
s Set: Choose a preset number and then enter a
name. This saves the current preset under the
specified preset number and name.
s Go to: Select a preset from the list and then
click Go to to move the camera to the selected
preset position.
s Edit: Used to change the selected preset's
name.
s Remove: Used to remove the selected preset.
2 Scan
Used to set up a profile for moving the camera
between two points. At least two presets must be
available in order to use the scan feature.
s Set: Used to set up a scan profile.
- Name: Enter a name for the scan profile.
- Start/Stop: Specify which presets to use as
start and stop points.
- Dwell Time (sec.): Specify how long the
camera will dwell at start and stop positions.
- Speed/Direction: Specify scanning speed
and direction.
s Test: Select a scan profile and then click Test to
test it.
s Edit: Used to edit the selected scan profile.
s Remove: Used to remove the selected scan
profile.