Pacific Communications SmartIP-16PD User Manual - page 47
Part 3 - Configuration
47
Ř Focus Mode: Used to change the focus movement
format as Auto/Manual/Semi-Automatic. It may not
be supported depending on the device.
Ř Shutter Speed Control: Adjust Shutter Speed. This
option is available only when Anti-Flicker and Slow
Shutter are both set to Off.
- Auto: The system will assess the lighting
conditions and adjust the shutter speed
automatically.
- Manual: Use the slider to select the desired
shutter speed. Select the most suitable minimum
and maximum shutter speeds for the lighting
conditions in the area where the camera is located.
(1/30 to 1/8000)
Select Apply after setting up a camera to see
images from the concerned camera on the left side
of the screen. Selecting Apply or OK displays a
popup screen that indicates whether the camera has
been set up successfully or not.
Stream
Configure the camera's live and recording resolution,
compression method, picture quality, transfer speed,
and ips speed settings.
Ř Camera Channel: It's possible to configure a unique
video profile for each camera.
Ř Copy to Camera: Apply the video profile settings
of the camera selected under Camera Channel to a
different camera.
Ř Live/Remote Video Profile: Check the current Live
video picture quality and edit remote video profile
settings.
- Use Dynamic Remote Stream: Automatically
transmits the Live 1 (Single Screen), Live 2 (2x2),
or Remote (greater than 2x2) stream, depending
on the remote program's live screen layout.
Ř Record Video Profile: Set up 4 recording quality
profiles.
Ř Video Profile: Select Live 1, Live 2, Remote,
or Custom (available from Record Video Profile
only). Live 1 and Live 2 allows the user to change
Bitrate and Quality settings only and configures the
remaining settings automatically.
- Compression Method: Supports H.264.
- Resolution: Select a resolution supported by the
camera. Maximum available resolution is chosen
automatically based on the selected video profile.
- Quality: Select Very High, High, Standard, or
Low. You can assign different Quality settings to
different cameras.
- Bitrate: Select CBR or VBR. Transmitted data
size is fixed with CBR but varies depending on the
amount of movements in the images with VBR.
- ips: Select a value between 1 and 30. Maximum
ips is determined automatically based on the
selected video profile.
Audio
Configure audio recording settings for all cameras
simultaneously.