Pacific Communications SmartIP-16PD User Manual - page 55
Part 3 - Configuration
55
Ř Activation Time: Specify how long audio detection
has to last in order for it to be considered an event.
Audio detections that do not last for the specified
duration of time will not be considered as events.
Ř Actions: Specify which actions to take when audio
detection events occur.
- Record: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
- Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
- Notify: Configure to be notified of events by Mail,
LAN1 through 5, SNS, and/or Alert Window.
- PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
Ř Ignoring Interval: The system does not produce
event log entries or issues remote notifications
regarding audio detected during the specified time
following the initial audio detection. Set a value
between 1 sec and 5 secs or choose Never.
Ř Use Ignoring Time: Select Time Setup to specify
the audio detection ignore time. Audio detection will
be disabled during the specified time frame.
Text-In
Ř Setup: Configure text-in devices.
Ř It's possible to batch configure all text-in devices
with the exception for port settings.
Ř An influx of large amounts of text-in data from
multiple channels can hinder system performance.
Ř Text-In Product: The setup window is updated so
that the portion below the port setting matches the
corresponding text-in device. Displayed screenshot
illustrates Generic Text settings.
Ř Transaction Start: Once Transaction Start has
been designated, the system will recognize the
specified string as the beginning of a transaction.
You can choose the Any Character setting. Under
this setting, any character will trigger the system into
recognizing the start of a new transaction.
Ř Transaction End: Once Transaction End has
been designated, the system will recognize the
specified string as the end of a transaction. Select 0
more line(s) next to Transaction End and specify a
value between 1 and 10. The system will recognize
the specified Transaction End string plus the
number of lines as being the end of a transaction.
Ř Line Delimiter: Designate a string to mark the end
of a line. You can enter control strings by selecting
and then entering ^, followed by a letter. For
example, Carriage Return is ^M and Line Feed (new
line) is ^J.
Ř Ignore String: Specify a string to ignore from
transaction records.
Ř Case Sensitive: Ignores case in strings designated
under Transaction Start, Transaction End, Line
Delimiter, and Ignore String.
Case Sensitive does not apply to control strings.