Xerox 4595 System Administration Manual - page 47
Xerox 4595 Copier/Printer System Administration Guide
2-13
2. Configuration
Configuration on the machine
This section describes the configuration procedure to connect the
machine to EtherTalk network.
Enable the EtherTalk port
NOTE 1: The configuration can also be performed using
CentreWare Internet Services or CentreWare Utilities.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to “Using CentreWare Internet Services” on page 3-1.
1.
Display the
System Administrator Menu
screen.
a. Press the
Log In/Out
button.
b. Enter the UserID using the numeric keypad and select
Confirm
.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select
System Settings
.
2.
Enable the EtherTalk port
a. Select
System Settings
.
b. Select
Network Settings
.
c. Select
Port Settings
.
d. Select
EtherTalk
and select
Change Settings
.
e. Select
EtherTalk - Port
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
3.
Select
Close
repeatedly until the
System Settings
screen is
displayed.
4.
Select
Exit
.
5.
After the machine is restarted, print out the
Printer Settings
List
to confirm that the EtherTalk port is enabled.
Configure EtherTalk as necessary. Refer to “EtherTalk” on page 3-
7 for the EtherTalk configuration.