Xerox 4595 System Administration Manual - page 94

Xerox 4595 Copier/Printer System Administration Guide

5-4

5. Using the Scan Service

NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx” 

where xxx should be a numeric value in the range from 0 

to 255. However, 224 or 225.xxx.xxx.xxx and 

127.xxx.xxx.xxx cannot be used.

NOTE 2: Specify the subnet mask by a combination of the 

numbers 0, 128, 192, 224, 248, 252, and 255. However, 

you cannot use 0 between non-zero values.

NOTE 3: If you do not wish to set the gateway address, 

enter “0.0.0.0.”

4.

Select 

Close

 repeatedly until the 

System Settings

 screen is 

displayed.

5.

Select 

Exit

.

6.

After the machine is restarted, print out the Printer Settings 

List to confirm that the mail send port is enabled and TCP/IP is 

configured.

Configuring the E-mail environment

This section describes the configuration procedure to use the 

scanner (mail transmission) function.

NOTE 1: The configuration can also be performed using 

CentreWare Internet Services.

NOTE 2: Enable the SOAP port and the SNMP port in most cases.

Refer to “Using CentreWare Internet Services” on page 3-1.

1.

Display the 

System Administrator Menu

 screen.

a. Press the 

Log In/Out

 button.

b. Enter the UserID using the numeric keypad and then 

select 

Confirm

.

NOTE: The default User ID value is 11111. When using the 

Authentication feature, a password is required. The default 

password is x-admin.

c. Select 

System Settings

.