4RF Aprisa XE User Manual - page 148
146 | Cross Connections
Aprisa XE User Manual
Installing the Cross Connections Application
The Cross Connections application is usually started directly from SuperVisor without the need for
installation.
However, if you want to use the Cross Connections application offline (without any connection to the
terminals), you can install it on your PC. Working offline enables you to simulate new cards or terminal
capacities. The cross connections can then be configured and the resulting configuration file saved for
later deployment.
To install the Cross Connections application on your PC, navigate to the Cross Connect directory on the
supplied CD and copy the application (ccapp_exe_x_x_x.jar where x is the version) to a suitable place on
your PC hard disk.
Your PC 'File Types' must associate a *.jar file with the Executable Jar File so that when the *.jar file is
clicked on (or double clicked on), it will be executed with Javaw.exe. If clicking on (or double clicking on)
the jar file does not bring up the Cross Connections application, the 'File Types' needs to be setup in your
PC.
Go to 'My Computer / Tools / Folder Options / File Types’ and click 'New'.
Type 'Jar' in the 'File Extension' box and click OK.
Click 'Change' and 'Select a program from a list'
Select 'Javaw.exe' and click OK.
Opening the Cross Connections Application
To open the Cross Connections application from within SuperVisor:
Select Link > Interface > Cross Connections
To open the Cross Connections application without SuperVisor:
Navigate to the installed cross connections application file C-capp_exe_8_6_7.jar and double click on it.
Note: This assumes that you have copied the cross connections application to your PC so you can work
offline (without any connection to the terminals).