4RF Aprisa XE User Manual - page 35
Mounting and Installing the Terminal | 33
Aprisa XE User Manual
5. Mounting and Installing the Terminal
This section covers installing the hardware associated with the terminal. Before you begin a terminal
installation, read this section thoroughly.
CAUTION:
You must comply with the safety precautions in this manual or on the product itself.
4RF Limited does not assume any liability for failure to comply with these
precautions.
Required Tools
No special tools are needed to install the terminal other than those required to physically mount the
terminal into the rack.
Installing the Terminal
The terminal is designed for 19-inch rack mounting and is supplied with rack mounting brackets. The rack
brackets can be front, mid, or rear mounted (as shown below) to suit individual installation requirements.
Once the rack brackets are attached, carefully lift the terminal into position in the rack, and fasten with
screws and washers.