4RF Aprisa XE User Manual - page 62
60 | Managing the Terminal
Aprisa XE User Manual
SuperVisor Logging In
The maximum number of concurrent users that can be logged into a terminal is 5.
If SuperVisor is inactive for a period of 30 minutes, the terminal will automatically log out the user.
To log in to SuperVisor:
1. Open your web browser and enter the IP address of the terminal.
Note: If you haven't yet assigned IP addresses to the terminals, use the factory-configured IP addresses
(see ‘Changing the Terminal’s IP Address’ on page 64).
If you don't know the IP address of the terminal, you can determine it using terminal emulation
software (see ‘To Get or Set the IP Address of a Terminal Using Setup’ on page 58).
2. Login with the user name and password assigned to you.
Note: If unique user names and passwords have not yet been configured, use the default user names
and passwords (see ‘Setting up users’ on page 65).
Important: After you login for the very first time, it is recommended that you change the default
admin password for security reasons (see ‘Changing passwords’ on page 67).
3. Tick the ‘Use Popup Window’ tick box if you want a separate browser window to launch after you have
logged in. The login page remains open in one window allowing you to view or configure settings in
another page. This is useful if you have more than one link to configure, for example, protected
terminals.
4. When you have logged in, the Summary page shows a summary of both the Local and Remote
terminals’ parameters.