4RF Aprisa XE User Manual - page 87
Configuring the Terminal | 85
Aprisa XE User Manual
Configuring SNMP Settings
In addition to web-based management (SuperVisor), the terminal can also be managed using the Simple
Network Management Protocol (SNMP). MIB files are supplied, and these can be used by a dedicated SNMP
Manager, such as Castle Rock's SNMPc (
), to access most of the terminal's configurable
parameters.
However, it is recommended that SNMP is only used for status and alarm monitoring of your entire
network. SuperVisor is the best means to configure individual terminals.
For communication between the SNMP manager and the terminal, Access Controls, Trap Destinations, and
Community strings must be set up as described in the following sections.
A SNMP Access Control is the IP address of the terminal used by an SNMP manager or any other SNMP
device to access the terminal. Entering an IP address of ‘Any’ (not case sensitive) or
*
will allow any IP
address access to the terminal. A community string is sent with the IP address for security.
Commands are sent from the SNMP manager to the terminal to read or configure parameters of the
terminal e.g. setting of interface parameters.
A SNMP Trap Destination is the IP address of a station running an SNMP manager. A community string is
sent with the IP address for security.
Events are sent from the terminal to the SNMP manager e.g. alarm events.
A SNMP Community String is used to protect against unauthorized access (similar to a password). The
SNMP agent (terminal or SNMP manager) will check the community string before performing the task
requested in the SNMP message . Trap Destinations and Access Controls both use community strings for
protection.
To configure Trap Destinations and Access Controls:
Select Local > Maintenance > SNMP > SNMP Settings
Note: SNMP Settings can only be setup on the local terminal.