4RF Aprisa XE User Manual - page 151
Cross Connections | 149
Cross Connections Toolbar
The cross connections toolbar has buttons for commonly-used functions.
Button
Explanation
Saves the cross connection configuration file to disk. The button turns amber when
you have made changes that have not yet been saved.
Gets the cross connection configuration from the local and remote terminals.
Saves the cross connection configuration to the local and remote terminals. The
button turns amber when you have made changes that have not yet been sent to
the terminal.
Activates the cross connections on the local and remote terminals. Turns amber
when there are cross connections that have been sent but not yet activated.
Expands all the ports for all the interface cards.
Collapses all the ports for all the interface cards.
Opens the symmetrical connections wizard.
Setting the Terminal's IP Address
If the Cross Connections application is launched from SuperVisor, the terminal IP addresses are set
automatically by SuperVisor, but if the application is launched from your PC independent of SuperVisor,
you will need to set the application Local and Remote IP addresses to the addresses of the Local and
Remote terminals you wish to connect to.
To set the application local or remote IP address:
1. Right-click over the terminal name or IP address and select Set Address.
2. Select Local or Remote > Set Address
3. Enter the IP address of the terminal in the dialog box and click OK.