4RF Aprisa XE User Manual - page 19
Getting Started | 17
Aprisa XE User Manual
Phase 4: Configuring the traffic
1.
Confirm that the interface hardware and software slot configurations
match.
2.
Confirm the interface card settings.
Page 92
3.
Open the Cross Connections application and configure the cross
connections:
Download the configuration.
Confirm or modify the traffic cross connections.
Save the configuration to the terminal.
Activate the configuration.
Page 146
4.
Save the configuration to disk and close the Cross Connections
application.
Page 155
5.
Connect the connection of interface cables.
6.
Confirm or adjust the terminal clocking for network synchronization, if
required.
7.
Test that the traffic is passing over the link as configured.
8.
Confirm or configure the external alarm settings in SuperVisor.
Page 81
9.
Setup an external alarm connection cable, if required.
10. Reset any alarms and error counters.
Page 244
11. Perform traffic pre-commissioning tests (optional)
12. Complete the commissioning form (at the back of the manual) and file.
Page 327