4RF Aprisa XE User Manual - page 71
Configuring the Terminal | 69
Aprisa XE User Manual
8. Configuring the Terminal
Configuring the RF Settings
The RF settings are factory-configured before dispatch to the customer requirements. However, you can
change the RF settings, if required.
If two fundamental radio parameters (RX and TX frequency or modulation) are changed on the remote
terminal in the same apply action (simultaneously), the first parameter change could break the
communications link to the remote terminal and prevent the other commands from being actioned. There
is a two second delay between receiving the command and actioning it to allow for subsequent commands
to be received before the communications link is lost.
To configure RF settings:
Select Link or Local or Remote > Terminal > Basic:
Note: Transmit frequency, transmit power, channel size, modulation and antenna polarization would
normally be defined by a local regulatory body and licensed to a particular user.
Refer to your site license details when setting these fields.