4RF Aprisa XE User Manual - page 18
16 | Getting Started
Aprisa XE User Manual
Phase 3: Establishing the link
1.
If you don't know the terminal's IP address :
Connect the setup cable between the terminal's Setup port and the PC
using accessory kit adaptor.
Use HyperTerminal to confirm the IP settings for the terminal:
Local IP address
Local subnet mask
Remote terminal IP address
Reboot the terminal
Page 58
2.
Connect the Ethernet cable between the terminal's 4-port Ethernet
switch and the PC.
3.
Confirm that the PC IP settings are correct for the 4-port Ethernet
switch:
IP address
subnet mask
Page 50
4.
Confirm that Java is installed on the PC.
Page 49
5.
Start the web browser, and log into the terminal.
Page 60
6.
Set or confirm the RF characteristics:
TX and RX frequencies
Modulation type
TX output power
Page 69
7.
Compare the actual RSSI to the expected RSSI value (from your path
planning).
8.
Fine-align the antennas.
Page 201
9.
Confirm that the terminal clock sources are set correctly.
Page 73
10. Confirm that the TX and RX LEDs are green. Disregard the OK LED status
for now.