4RF Aprisa XE User Manual - page 93
Configuring the Traffic Interfaces | 91
Aprisa XE User Manual
9. Configuring the Traffic Interfaces
Important: When configuring a link, it is important that you configure the remote terminal first as the
new configuration may break the management connection to the remote terminal.
Once the remote terminal has been configured, the local terminal should be configured to match the
remote terminal.
Viewing a Summary of the Interfaces
To view a summary of the interfaces fitted:
Select Link or Local or Remote > Interface > Interface Summary.
The Interface Summary page shows:
The interface type for each slot that has been configured with the capacity used by each port.
Total Capacity. The total capacity of the radio link.
Ethernet Capacity. The capacity allocated to the Ethernet traffic over the radio link. This includes
the user and management capacity assigned.
Management Capacity. The capacity allocated to the management conduit over ethernet.
Radio Capacity. The percentage of the total capacity of the radio link that has been allocated to
traffic interfaces.
Drop and insert capacity. The percentage of the total drop and insert capacity used for local drop
and insert cross connections. The total drop and insert capacity is 65536 kbit/s minus the assigned
radio link capacity.
Some interfaces also require extra bandwidth to be allocated to transport signalling, such as CTS / DTR
handshaking or E&M signals. The cross connections application automatically allocates capacity for
signalling when it is needed.