ABB i-bus KNX Product Manual - page 68
ABB i-bus
KNX
Commissioning
66 2CDC 507 100 D0202 | DLR/S 8.16.1M
With the option Yes, the following parameters appear:
Send
Options:
After a change
On request
After a change or request
After a change: The status is sent via the communication object after a change.
On request: The status is sent after a request by the communication object Request status
values.
After a change or request: The status is sent via the KNX when the status changes or the
status is requested via the communication object Request status values.
"Fault group/device code"
enable encoded fault message
Options:
No
Yes
With this parameter, the communication object Fault group/device code must be enabled. The fault status
(lamp and ballast fault) of the lighting groups or the individual DALI devices are sent on the KNX.
For further information see:
Communication object no. 19
Code table Fault group/device code (no. 19)
page 206
No: The communication object Fault group/device code is not enabled.
Yes: The communication object Fault group/device code is enabled. The following parameter appears:
Send number of the failed group
or failed device
Options:
Group oriented
Device oriented
This parameter determines whether the fault relates to a lighting group or an individual DALI device.
Group oriented: The values of the communication objects Fault group/device code (no. 19) and
no. Group/device fault (no. 21) relate to a lighting group fault. The numbers of the lighting
groups and information about the lighting groups are sent.
Device oriented: The values of the communication objects Fault group/device code (no. 19)
and no. Group/device fault (no. 21) relate to a DALI device fault. The numbers (DALI short
address plus 1) of the DALI devices and information about the DALI devices are sent.