Canon Color imageRUNNER C4580 Service Manual - page 141
Chapter 5
5-11
10
4
BOOTDEV
Firmware
save area
(Bootable,
MEAP, key,
ID, PDF
dictionary,
RUI contents,
audio
dictionary
(ICC profile,
PS test data))
#3
#8
#9
#10
#11
#12
System
Impossible Impossible
11
5
APL_MEA
P
MEAP
#1
#5
#9
#10
#11
#12
MEAP
Possible
Possible
12
6
APL_SEN
D
Address book,
filter
#2
#5
#9
#10
#11
#12
SEND
Impossible Impossible
13
7
APL_KEEP
MEAP save
data
#3
#8
#9
#10
#11
#12
System
Impossible Impossible
14
8
APL_LOG
System log
save area
#1
#5
#9
#10
#11
#12
Log
Possible
Possible
F
F
0
Cannot be
identified
Overall HDD
fault sector
check and
restore
#4
#7
#9
#10
#11
#12
-
-
-
YY
Contents
Remedy
#1
03
Write Abort (during
startup)
1. Enter CHK-TYPE for the partition, execute HDD-CHECK (may take anywhere
from several minutes to several tens of minutes), and then turn the power OFF and
then ON again.
2. If the above does not restore the system, enter CHK-TYPE for the partition,
execute HDD-CLEAR, and turn the Main Power Switch OFF and then ON again.
#2
03
Write Abort (during
startup)
1. If possible, have the user pull up address log data by remote UI.
2. Enter CHK-TYPE for the partition, execute HDD-CHECK (may take anywhere
from several minutes to several tens of minutes), and then turn the power OFF and
then ON again.
3. If the above does not restore the system, enter Download Mode, perform a full
format using SST, reinstall the system (System, Lang, RUI), and turn the Main
Power Switch OFF and then ON again.
#3
03
Write Abort (during
startup)
Repair operations in the boot partition can only be performed when using SST in
Safe Mode.
1. Set CHK-TYPE = 0, execute HDD-CHECK (may take several tens of minutes),
and then turn the power OFF and then ON again.
2. If the above does not restore the system, enter Download Mode, perform a full
format using SST, reinstall the system (System, Lang, RUI), and turn the Main
Power Switch OFF and then ON again.
#4
03
Write Abort (during
startup)
1. Set CHK-TYPE = 0, execute HDD-CHECK (may take several tens of minutes),
and then turn the power OFF and then ON again.
2. If the above does not restore the system, execute HDD-CLEAR for CHK-TYPE
= 1, 2, 3, 5, and then turn the power OFF and then ON again.
#5
05
File system error
1. Enter CHK-TYPE for the partition, execute HDD-CLEAR, and turn the Main
Power Switch OFF and then ON again.
2. If the above does not correct the problem, the HDD may be assumed to be
damaged, so replace the HDD and reinstall the system.