Canon Color imageRUNNER C4580 Service Manual - page 769
Chapter 19
19-124
19.6 TEST (Test Print Mode)
19.6.1 COPIER
19.6.1.1 COPIER Table
1. PG
T-19-68
COPIER>TEST>PG
Sub item
Description
level.
TYPE
Performs test print when test print type number is entered and start key is turned ON. (This
setting must always be restored to 0 after making test print.)
Setting values
0: Normal print, 0 to 100
[Factory default/After RAM clear: 0]
1
TXPH
Used to set image mode during test print output.
Setting values
0: Text mode
1: Photo mode
2: Automatic mode
3: Text/photo/map mode
4: Photographic printing paper photo mode
5: Printed photo mode
6: Text/photo mode
7: Black and white text mode
Reference:
This setting is only valid for test prints.
[Factory default/After RAM clear: 0]
1
THRU
Used to select whether to use image compensation table during test print output.
Setting values
0: ON (Use)
1: OFF (Don't use)
[Factory default/After RAM clear: 0]
1
DENS-Y/M/C/K
Used to adjust density of each color for test prints (TYPE = 5).
Setting values
0 to 255: Increasing the value increases the density.
[Factory default/After RAM clear: 128]
1
COLOR-Y/M/C/
K
Used to set output of each color for each TYPE.
For example, to set single-color M output, set "COLOR-M = 1", and make the other
settings 0 (only single colors can be output).
Setting values
0: Don't output
1: Output
[Factory default/After RAM clear: 1]
1
F/M-SW
Set it to switch over full color and mono color during PG output.
Settings
0: full color output
1: mono color output
[Factory default/After RAM clear: 0]
1