Canon Color imageRUNNER C4580 Service Manual - page 757
Chapter 19
19-112
CC-SPSW
use it to enable/disable support of the switch in relation to the support level of the control guard I/F
0: do not support [Factory default/After RAM clear]
1: support (priority on speed)
2: support (priority on upper limit on number of prints)
Reference:
negative effects of '1'
- the machine may fail to use an accurate stop based on the upper limit
negative effects of '2'
- some source of power (pickup assembly) may suffer a drop in productivity
2
UNIT-PRC
Unit price setting for coin vendors
Sets unit price for coin vendors.
Setting values
0: yen
1: euro
2: pound
3: Swiss franc
4: dollar
[Factory settings and after RAM clear: 0]
2
DA-PUCT
Pickup/ delivery notification setting for charged output
This mode prevents prints from being output for free if some kind of network trouble interferes
with the pickup/ delivery notification (if Ack is not returned after DA) by continuing to output the
notification.
Setting values
2 to 10
[Factory settings and after RAM clear: 6]
E.g.
If the value is 5, if Ack is not returned after DA, 5 sheets will be picked up. -> If iR-DA
communication is disrupted for some reason, the device will still operate for 5 sheets (printed out
without charging).
If the setting values are too low, the demerit is that engine performance will suffer.
And, depending on the model, the reference value can be changed (because of the relationship with
engine speed).
- When the setting values are low, the number of sheets that can be output without reducing the
tariff becomes lower.
Engine performance may suffer.
- When the setting values are high, the number of sheets that can be output without reducing the
tariff increases.
Engine performance does not suffer.
2
COPIER>OPTION>ACC
Sub item
Description
level.