Canon Color imageRUNNER C4580 Service Manual - page 687
Chapter 19
19-42
50-GB
Use it to indicate the degree of offset (color displacement; GB) for book mode at 50% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
100-RG
Use it to indicate the degree of offset (color displacement; RG) for book mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
100-GB
Use it to indicate the degree of offset (color displacement; GB) for book mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
50DF-RG
Use it to indicate the degree of offset (color displacement RG) for ADF mode at 50% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
50DF-GB
Use it to indicate the degree of offset (color displacement; GB) for ADF mode at 50% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
100DF-RG
Use it to indicate the degree of offset (color displacement; RG) for ADF mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
100DF-GB
Use it to indicate the degree of offset (color displacement; GB) for ADF mode at 100% reading.
Method of Adjustment
- if you have initialized the RAM on the reader controller PCB or replaced the reader controller
PCB, enter the value indicated on the service label.
Range of Adjustment: -256 to 256 [Factory default/After RAM clear: 0]
Attention
If you have changed the setting, be sure to record the new setting on the service label.
1
COPIER>ADJUST>CCD
Sub item
Description
level.