Canon Color imageRUNNER C4580 Service Manual - page 730
Chapter 19
19-85
DA-CNCT
Setting connection to DA
Settings
1: DA is used
2: DA is not used [Factory default/After RAM clear:0]
The following modes also become ON when COPIER>OPTION>BODY>DA-CNCT is set to '1'.
COPIER>OPTION>BODY>STS-PORT
COPIER>OPTION>BODY>CMD-PORT
COPIER>OPTION>BODY>SSH-SW
COPIER>OPTION>BODY>DA-PORT
MEMO:
This is used only inside Japan, not outside Japan.
2
FXMSG-
SW
Use it to enable/disable the message that prompts replacement of the fixing assembly.
Use it to enable/disable the message on the control panel indication the need for the replacement of
the fixing assembly.
Normally, the setting is enabled; however, you can disable the message if there is no need for
replacement (so that the user will not
feel unnecessarily concerned and place a service call). If replacement is necessary, be sure to replace
it and enable the setting.
Settings
0: do not indicate
1: indicate
a time of shipment/upon RAM initialization: 1
2
CHNG-STS Use it to set the T.O.T (TUIF over TCP/IP) status connection port number.
Changes the port number for status connection in a TUIF over TCP/IP environment. This is used for
changing the port No. in service NAVI.
settings
1 to 65535 (default: 20010)
MEMO:
T.O.T (TUIF over TCP/IP)
Communication protocol between embedded application presentation (UI) and applications within the
device including COPY/SEND/BOX etc., (Canon original protocol)
CHNG-
CMD
Use it to set the T.O.T (TUIF over TCP/IP) command connection port number.
Use it to set the port number for the command connection in an TUIF over TCP/IP environment. This
is used for changing the port No. in service NAVI.
settings
1 to 65535 (default: 20000)
MEMO:
T.O.T (TUIF over TCP/IP)
Communication protocol between embedded application presentation (UI) and applications within the
device including COPY/SEND/BOX etc., (Canon original protocol)
2
MEAP-DSP Use it to prohibit a switch-over from the MEAP screen to the standard screen (COPY/SEND/BOX
screen etc.,).
settings
0: off (shift to standard screen; default); 1: on (do not shift to atandard screen)
MEMO:
Although setting the value as '1' in COPIER > OPTION > BODY > MEAP-DSP, at the occurrence of
error/jam/alarm, the display transits to the standard screen for showing a warning.
2
COPIER>OPTION>BODY