Canon Color imageRUNNER C4580 Service Manual - page 745
Chapter 19
19-100
JA-FUNC
Job archive function ON/OFF
When ON, the job archive function is activated.
*The settings cannot be changed in service mode, but only referenced.
Settings can only be made from a job archive-enabled MEAP programme.
Setting values
0: OFF
1: ON
[Factory settings and after RAM clear: 0]
2
JA-JOB
Designates job archive jobs.
When the job archive function is activated, the job archive operates when a job is run, in
accordance with the job type designation.
*The settings cannot be changed in service mode, but only referenced.
Settings can only be made from a job archive-enabled MEAP programme.
Setting values
0: None
3: FAX/IFAX only
0xFFFFFFFF: all jobs
[Factory settings and after RAM clear: 0]
2
JA-RESTR
Job archive restriction settings
When the job archive function is activated, spec. restrictions are applied against those functions
for what spec. restrictions are set.
*The settings cannot be changed in service mode, but only referenced.
Settings can only be made from a job archive-enabled MEAP programme.
Setting values
0, 1
32 spec. restrictions by bit setting.
Bit0: Image file acquisition function (0: OFF, 1: ON)
Bit1: Form registration merge function (0: OFF, 1: ON)
Bit2: Document edit function (0: OFF, 1: ON)
Other bits are not set, but will be added as and when needed. (4 byte needed)
[Factory settings and after RAM clear: 0]
2
DOM-ADD
Sets domain complement for transmission destination when sending email.
Sets whether to complement the domain (e.g. @canon.co.jp) programmed in the user mode to
the entered account when transmitting email.
Setting values
0: Do not complement Tx destination domain.
1: Complement Tx destination domain.
[Factory settings and after RAM clear: 0]
2
JA-DPI
Specifies job archive record resolution.
For jobs other than PC-FAX, FAX Rx, IFAX Rx, etc., the resolution is converted to the
programmed resolution and an archive image is recorded.
*The settings cannot be changed in service mode, but only referenced. Settings can only be
made from a job archive-enabled MEAP programme.
Setting values
0 : No not convert resolution.
1: 100 x 100 dpi
2: 200 x 200 dpi
3: 300 x 300 dpi
[Factory settings and after RAM clear: 3]
2
COPIER>OPTION>USER
Specification selection related to user mode