Canon Color imageRUNNER C4580 Service Manual - page 741
Chapter 19
19-96
IFAX-OF
Sets IFAX address transmission prohibition.
This setting prohibits transmission to an IFAX address by prohibiting IFAX address entry into
the address book.
Setting values
0: Do not prohibit transmission to IFAX address.
1: Prohibit transmission to IFAX address.
[Factory settings and after RAM clear: 0]
1
LDAP-DEF
Switches LDAP search condition defaults.
Sets default search attributes when LDAP detailed search is selected.
Setting values
0: 'Name'
1: 'Email'
2: 'Fax'
3: 'Organisation'
4: 'Unit'
5: User setting 1
6: User setting 2
[Factory settings and after RAM clear: 0]
1
SIZE-DET
Sets document size detection function ON/ OFF.
When the pressure plate opens and closes, there is no light flashing, so extraneous light can be
cut out.
Setting values
0: OFF
1: ON
[Factory settings and after RAM clear: 1]
2
2
DATE-DSP
Used to switch date display.
0: 'YYMM/DD
1: DD/MM'YY
2: MM/DD/YY
2
MB-CCV
Used to select whether to restrict mailbox control card users.
0: Don't restrict
1: Restrict
2
TRY-STP
Used to set mode in which output stops when tray is full.
0: Normal mode (Interrupted when finisher tray is full.)
1: Interrupted only by height detection
2
MF-LG-ST
Sets long length mode key.
Setting values
0: Normal setting
1: Display long length key in mode screen.
[Factory settings and after RAM clear: 0]
2
CNT-DISP
Used to select whether to display serial number when counter check key is pressed.
0: Display serial number.
1: Don't display serial number.
2
OP-SZ-DT
Used to turn document size detection when pressure plate is open ON/OFF.
0: Enter document size in control panel.
1: Detect document when start key is turned ON with pressure plate open.
2
NW-SCAN
Used to select whether to permit network scan function
0: Don't permit
1: Permit (Invalid when UFR board or open interface board isn't connected.)
2
COPIER>OPTION>USER
Specification selection related to user mode