Canon Color imageRUNNER C4580 Service Manual - page 639
0000 When communication between the
reader and ADF was interrupted
and 5 or more sec. have elapsed
without communication having
been restored
Check the connector connections between the reader and ADF.
E713
Finisher/printer communication error
0004 When communication between the
finisher and copier was interrupted
Check the cable connections. Replace the finisher controller PCB. Replace
the DC controller PCB.
E716
Cassette pedestal/printer communication error
0000 When trouble occurs in the data
communication. When the DC
controller or cassette pedestal
controller PCB is defective
Check the cable connections. Replace the pedestal PCB. Replace the DC
controller PCB.
E717
Error in communication with NE controller
0001 When the NE controller which was
connected before the power was
turned OFF could not be recognized
when the power was turned back
ON
Check the cable connections.
0002 When the IPC has a broken or
disconnected wire or when an error
has occurred where IPC
communication cannot be
recovered
In the service mode, clear the error by selecting COPIER > FUNCTION >
CLEAR > ERR.
E719
Error in communication with coin vendor/card reader
0001 When the coin vendor which was
connected before the power was
turned OFF could not be recognized
when the power was turned back
ON
Check the cable connections.
0002 - When a wire in the IPC cable
connected with the coin vendor is
broken or disconnected or when an
error has occurred where IPC
communication cannot be
recovered
- When a broken or disconnected
wire in the sheet feed/delivery
signal line was detected
- When an illegal connection has
been detected (when Tx and Rx of
IPC have been short-circuited)
In the service mode, clear the error by selecting COPIER > FUNCTION >
CLEAR > ERR.
0011 When the card reader which was
connected before the power was
turned OFF could not be recognized
when the power was turned back
ON
0012 When a wire in the IPC cable
connected with the card reader is
broken or disconnected or when an
error has occurred where IPC
communication cannot be
recovered
E730
PDL error
Displayed
code
Detection timing
Remedial action