IBM Proventia Network Enterprise User Manual - page 104
Chapter 7: Configuring Discovery and Assessment Policies
104
IBM Internet Security Systems
Example: Checks by
groups
Figure 22 is an example of grouping checks by Category, Severity, and then Impact. The
category, CGI-Bin, contains checks with High, Medium, and Low severity. Within the
High severity checks, five have no impact while one may crash an asset:
Figure 22: Check grouping example
Creating groupings
To modify the Check Information list:
1. In the SiteProtector Console, set up a tab to display asset policies. (See page 74.)
2. On the navigation pane, select a group, and then open the Assessment policy for that
group.
3. Do any of the following
that is sorted and reverse its sort
order
click the column heading.
The sort order is reversed.
in a particular order
right-click the column heading, and then select either
Sort Ascending or Sort Descending from the pop-up
menu.
when vulnerabilities are displayed
in groupings
click the column heading, and then expand the groups to
see the effect of the sorting.
If you want to sort a column…
Then…
If you want to…
Then…
group by a single column
right-click a column, and then select Group by from the pop-up
menu.
group by multiple
columns
click
, and then move the columns you want to group by from
the All Columns list to the Group By These Columns list in the
order you want to group by.
Note: If the column you want to group by is not available, add it,
and then try again.