IBM Proventia Network Enterprise User Manual - page 34
Chapter 2: Installing and Configuring an Agent
34
IBM Internet Security Systems
9. Select Finish, and then press
ENTER
.
The Setup Complete screen appears.
10. Press the
ESC
key, select Yes to exit the Proventia Setup Assistant, and then press
ENTER
.
11. Disconnect your cables as follows:
12. Do one of the following:
■
If you want to configure explicit trust with your Agent Manager, go to
“Configuring Explicit-Trust Authentication with an Agent Manager” on page 35
■
If you want to continue setting up your appliance, go to “Registering Enterprise
Scanner to Connect to the SiteProtector System” on page 37.
Time Zone
The Time Zone for your appliance.
Tip: Press
ENTER
to display the choices in the list, and then press
the up and down arrows to select a choice.
Date and Time
The current Month, Day, Year, Hours, and Minutes for your
appliance.
Important: You must use a 24-hour time format.
Note: If the date and time are correct, you do not need to change
anything. You only need to change fields that are not already correct
in the Current System Date and Current System Time boxes.
Root Password
The password required to log on to the operating system of your
appliance.
Administrator
Password
The password required to access the Proventia Setup Assistant on
the appliance.
Proventia Manager
Password
The password required to access Proventia Manager through a Web
browser over a network connection.
Bootloader
Whether to require (Enable) or not require (Disable) the Bootloader
(root) password for backup and restore operations only.
Caution: If you enable the Bootloader password, you must use a
serial connection to the agent through a serial port and supply a
password to backup or restore the appliance; you do not need to be
connected for other operations.
Settings Review
A list of all the configuration settings you have chosen.
Tip: Press the
DOWN
ARROW
to see the complete list of settings
and to see the Finish button.
If you are using…
Then disconnect the following cables…
terminal emulation
•
the RJ45 connection from the serial port on the back of the
computer
PXE bootserver for a
reinstallation (see
“Reinstalling an
Enterprise Scanner
Agent” on page 209)
•
the RJ45 connection from the serial port on the back of the
computer
•
the red crossover cable from management port of the
appliance to the Ethernet port on the boot server computer.
•
and then press
CTRL
+
G
to eject the installation disk.
Screen
Descriptions