IBM Proventia Network Enterprise User Manual - Configuring An Http Proxy
Chapter 16: Updating Enterprise Scanner
222
IBM Internet Security Systems
Configuring an HTTP Proxy
Introduction
If your agent uses an HTTP proxy server to get to the XPU server, configure the proxy
server on the Proxy Server page of the Update Settings Policy.
Procedure
To configure a proxy server:
1. From the SiteProtector Console, open the Update Settings Policy, and then select the
Proxy Server
tab.
2. Select Enable Proxy.
3. Complete the following fields:
Field
Description
Address
The address of the proxy server.
Port
The port of the proxy server.
Enable Authentication
Forces the agent to authenticate to the proxy server.
Note: The User ID and Password are required.
User ID/Password
If authentication is enabled, the User ID and Password the agent
uses to authenticate to the proxy server.