IBM Proventia Network Enterprise User Manual - page 50
Chapter 3: Running Your First Scans
50
IBM Internet Security Systems
Monitoring Ad Hoc Discovery and Ad Hoc Assessment Scans
Introduction
Follow the procedure in this topic to monitor the ad hoc discovery and ad hoc assessment
scans.
Procedure
To monitor the scans:
1. Right-click the group on the navigation pane, select Properties from the pop-up
menu, and then click Command Jobs on the navigation pane.
Tip:
Or click the Control jobs icon
on the toolbar.
The ad hoc discovery scan appears in the Command Jobs window, and the task name
appears under the Object column.
2. Click the Details-[Linked]First Ad Hoc Discovery tab.
The job-level statistics for the job appear.
Figure 7: Job-level statistics for an ad hoc discovery scan
Note:
[Linked]
prepended to the task name indicates that the assessment scan was
set up to run after the discovery scan has finished. The same prefix is attached to the
assessment scan to indicate that it is linked with a discovery scan.
Tip:
The status starts out as Pending, may go back-and-forth between Idle and
Processing
until it finishes, and then its status is Completed.
Tip:
For more information about how scan jobs run and how to find information
about them, see Chapter 10, "Monitoring Scans" on page 135.