Mediaedge Decoder User Manual - ■ Serial Log Output
- 120 -
MEDIAEDGE
Server function
It will connect to the device that had connection request on the remote serial
(It will connect to a device that issued the request first if there is a connection
request from multiple devices.)
Connection Parameter
Set up the following connection parameters to fit to the equipment that will
perform the remote connection.
The port number of access point
Initial value:60001. Specify the port number to transmit the communication
input from the serial port to the network.
Standby port number
Initial value:60001. Specify the port number for receiving the communication
to be output to the serial port from the network. The port number is
optional; however, the same number as the number being used in another
communication cannot be used.
Protocol
Set the same value as the protocol that the access point uses.
TCP
UDP
Initial value.
■ Serial Log Output
Set up whether to output the communication by the remote serial to the log.
Enable
It will output the content of the serial communication in the operation log.
Disable
Initial value. It will not output the content of the serial communication in the
log. Evenif it is set as [Disable], it may output in the error log when an error
occurs.
●
●
●
●
●
●
●
●