Mediaedge Decoder User Manual - page 22
- 22 -
MEDIAEDGE
(3) Information indicator
(5) Remote control indicator
T h e i n f o r m a t i o n i n d i c a t o r
displays the access condition of
the internal HDD/SSD and the
external storage.
x. Off
The external storage is not connected
or is write-protected.
xi. Flashing
The Decoder is writing to the internal
HDD / SSD or the external storage.
xii. On
The external storage has been
mounted in a writable state.
This indicator lights up when the
Decoder receives and recognizes
the remote control.
(4) Error indicator
The error indicator displays the
error condition due to hardware.
xiii. On or flashing
An error was detected.
xiv. Off
The Decoder is operating normally.
This indicator lights up when the
Decoder receives and recognizes
the remote control.
(6) Remote control sensor
The infrared receiver of remote
control is built in.
(7) Reset button
Use this to reset in case of
emergency. Do not use it in
normal situation.
* It will be switched to “maintenance
mode” when the reset button is pressed
for more than 5 seconds.
(8) SD card slot
The slot to insert the SD card.
* Only SD and SDHC memory cards are
usable.
Error indicator
When the failure of the equipment is detected, the error indicator will light up or start flashing.
If this happens, please contact our customer support.
Indicator that is lit at startup
Immediately after the power-on or the restart, the indicator will be lit for around 5 seconds to
initialize the hardware.