Mediaedge Decoder User Manual - page 35
- 35 -
MEDIAEDGE Decoder
When DHCP or monitor is available, it is possible to perform the
setting with the following procedure.
- Set the IP address of the PC as automatic acquisition.
- Turn on DIPSW-3 of the MEDIAEDGE Decoder.
- Connect the PC and the MEDIAEDGE Decoder to the same HUB and startup.
- Startup the MEDIAEDGE Finder in the PC. After obtaining the IP address, detect
the MEDIAEDGE Decoder.
- The detected host name of the MEDIAEDGE Decoder will be displayed also in “other
divice” of Windows 7 and Windows 8.
* When the MEDIAEDGE Decoder is started while DIPSW-3 is ON, despite of the setting
status, IPv6 will be enabled and IPv4 will acquire IP automatically (AutoIP if unable to
acquire with DHCP after 20 seconds) at the startup.
* If there is possibility that UPnP is disabled, please initialize the setting value before
performing.
●