Mediaedge Decoder User Manual - page 70
- 70 -
MEDIAEDGE
Account
Set the setup value and the account that are used to connect to the shared
drive.
The account of the initial value is “mediaedge,” and the password is not set.
Shared drive authority
Set up the shared authority for each drive. When it is disabled, that drive will
not be shared.
The shared drive authority can be set up separately from the write access
drive; however, when the drive is set on “read only,” writing cannot be
possible even if “read write” is set.
1-4 Content Update by SD Card and USB Storage
The update of the content that will be used in the schedule playback or in menu
mode will be possible by putting the content file to be updated and the update
control script (update.inst) into a SD card or an USB storage and inserting it to the
MEDIAEDGE Decoder. The MEDIAEDGE Decoder recognizes the connection of
the SD card and the USB storage and updates the drive content that is set as the
default drive. When the update of the content is completed, the playback will be
started in the new content and schedule.
Please refer to the chapter update control script concerning to the update control
script.
Notes
The information indicator will flash while updating the content.
If the SD card and the USB storage are pulled out while updating the content, the update may
not be completed properly, the file may break, or the playback may not run normally.
1-5 Direct Writing to the Device
When the SD card and the USB storage are used, it is possible to remove the
device from the MEDIAEDGE Decoder and write in the content directly from the PC.
The MEDIAEDGE Decoder supports NTFS and FAT16/32 as the file system.
●
●