Mediaedge Decoder User Manual - page 32
- 32 -
MEDIAEDGE
Finish Setting
To erase the setup meu, press the (CONF) key on remote control.
•
When the TV monitor is connected by a composite, and if nothing is displayed when
the (CONF) on the remote control is pressed, please switch to the monitor signal that
is compatible with the TV monitor by pressing the (DISP) on the remote control. By
pressing the (DISP) key on the remote control while the setup menu is being diaplayed,
the monitor signal will cycle through NTSC(J)-NTSC(US)-PAL-NTSC(J). ,
At the first startup after the initial setting, the setup menu will be will be displayed
automatically. Whether the settings are changed or not, the setup menu will not be
displayed from the second time. When necessary, display the screen by using the (CONF)
key on remote control.
Setup of Wireless LAN (only for Wi-Fi model)
The wireless LAN cannot be in the setup menu. After the wired LAN is set in the setup
menu, perform the setting of the wireless LAN from the Web console by following the
next chapter ”Setting from the Web console” over the wired network.