Mediaedge Decoder User Manual - 3-3 Operation

- 134 -

MEDIAEDGE

■ Starting the maintenance mode

Press the reset button in front for more than 5 seconds when the power is 

connected.  After a while, the top menu of the maintenance mode will be 

displayed on the screen of the terminal communication software.

+------- Maintenance mode TOP MENU -------+

|  1: IPv4 address setup 

|

|  2: Firmware update from a USB/SD drive |

|  3: Firmware download via HTTP/FTP 

|

|  4: Ping (Sending ICMP echo requests) 

|

|  5: Restore to factory settings 

|

|  6: Display hardware info 

|

|  0: Restart 

|

+-----------------------------------------+

Select Command ->

Each comman can be run by entering ENTER right after 1-6 and 0.

3-3 Operation

■ Setting of the IP address (IPv4 address setup)

To use the firmware update function via network and the Ping command, it is 

necessary to set up the IP address of the MEDIAEDGE Decoder in advance.

1.  Use the DHCP

The  IP  address  setting  of  the  MEDIAEDGE  Decoder  will  be  done 

automatically by the DHCP.

2.  Manual setup

The IP address setting of the MEDIAEDGE Decoder will be done manually.

Select 1 or 2 and set the IP address.

When only ENTER is entered, it will return to the top menu screen.

When the setting is completed normally, the IP address will be displayed.