QMS 2060 Operation - Prepare The Paper

Loading the 

Media Cassette

2-5

Consumables

Prepare the Paper 

s

Caution: Ensure that the media size matches the cassette size (for 

example, letter/A4 media must be loaded only when the letter/A4 

cassette is inserted or the universal cassette is set to letter/A4 size). 

Since the media cassette sends a media size signal to the printer 

controller, using a wrong size media will cause your image to be 

positioned incorrectly on the page or clipped. 

1 Unwrap the paper, pull the stack out, and then with one hand 

at each end of the stack, lift and hold it in a curved position.

» Note: Paper is packed in reams of 500 sheets. Do not unpack the 

paper above the printer as this might cause particles to fall into 

the printer components. Note the arrows on the wrapper. They 

show which side of the paper should be on the top when it is 

loaded in the cassette.

2 Grip each end of the stack firmly.

3 Straighten the stack, and then roll the fanned sheets from 

side to side to get air through the sheets and prevent static 

buildup.

4 Take off the top and bottom sheets

The top and bottom sheets sometimes have residual glue buildup 

that could cause the printer to jam.

Loading the 500-sheet Cassette

Load media in the 500-sheet cassette as follows. For 250-sheet cas-

sette instructions, see the next section.

» Note: Reload media cassettes only when the printer is not actively 

printing.