QMS 2060 Operation - page 31
Loading the
Multipurpose
Tray
2-19
Consumables
The label printing surface must cover the entire carrier sheet, and no
adhesive should come through on the surface. The adhesive and car-
rier sheet must withstand the fusing temperature (200
°
C/392
°
F).
Avery 5160 stock is qualified for use in this printer.
Keep the following in mind when printing labels:
n
Avoid using labels with exposed adhesive; it may stick to the toner
cartridge or the fixing roller, causing labels to peel off and printer
jams to occur.
n
Format label data in your application. Try printing your data on a
plain sheet of media first to check placement. This reduces the
number of label sheets you use.
n
Before printing labels, disable the duplexer if it’s installed, and
check the manual feed guides to make sure they’re not too tight
and buckling the labels.
Loading Labels in the Multipurpose Tray
Load the labels lengthwise (long edge first), face up, and with the top
of the page toward the right hand side of the printer.
See your application documentation for specific information on print-
ing labels.
Letterhead and Memo Media: Special
Considerations
Your printer supports the printing of letterhead or memo paper in two
ways:
n
From the multipurpose tray (up to 10 sheets)
n
From a cassette (standard or optional—up to 400 sheets)
Keep in mind the following:
n
The letterhead and memo paper must adhere to the media speci-
fications described in appendix B, “Technical Specifications,” of
the
Reference
.