QMS 2060 Operation - page 61
Handling the
Printer
4-3
Printer Care
n
Do not touch the electrical contacts, gears, or laser beam
devices. Doing so may damage the printer and cause the print
quality to deteriorate.
n
Keep media in the output tray at minimum level. If the media
stacks too high, your printer may experience media jams and
excessive media curl.
n
Lift the printer from the bottom only, using the grips. Make sure
two people are available to lift the printer when moving it.
M
WARNING!
Remember that the media feeder on the bottom of
the printer stack is not attached to the printer. Make sure you lift
the printer by the carrying grips on the bottom-most unit in the
stack. If the top unit is lifted alone, the bottom unit could fall off,
causing bodily injury or damage to the printer. If you need to lift
just the top unit, use the grips and make sure it detaches
completely from the cassette below before moving it to the side.
ACHTUNG!
Bitte beachten Sie, daß die Papierzuführungen
unterhalb des Druckers nicht fest mit dem Drucker verbunden
sind. Wenn Sie das gasamte Gerät hochheben wollen, greifen
Sie deshalb in die Griffmulden der untersten Papierzuführung.
Wenn Sie nur den Drucker hochheben, kann es sein, daß die
Papierzuführung sich löst und herunterfällt. Dabei können Sie
sich verletzen und der Drucker kann beschädigt werden. Deshalb
versichern Sie sich, daß die Papierzuführung nicht mehr mit dem
Drucker verbunden ist bevor Sie diesen Drucker an einen
anderen Platz stellen. Benutzen Sie unbedingt die Griffmulden
am Drucker, wenn Sie ihn transportieren wollen.