Riso HC5000T User Manual - page 30

1-15

1

Setting Up the Paper Receiving Tray

Set the Paper Receiving Tray.

Adjusting the Side Guides and Rear Guide Positions

The Side Guides and the Rear Guide move automatically to the optimum positions according to the printing paper size. Fine position 

adjustment can be performed on the Control Panel. For details, refer to "4.8  Paper Ejection"#p.2-24 of the menu setting.

1 

Open the Paper Receiving Tray in the 

direction shown by the arrow until it 

stops.

2 

Raise the Side Guides.

3 

Adjust the Arrangers.

Normally, when printing onto B4 or larger paper, take 

out the Paper Arrangers. Paper arrangement depends 

on the paper firmness and so on. Adjust the Paper 

Arrangers as needed.

4 

Raise the End Guide.

5 

Adjust the position of the End Guide 

Cushion.

Use the Paper Feed Pressure Adjustment Lever to set 

the cushion to [NORMAL] or [CARD] according to 

the paper quality.

Do not pull out the Cushion from the Cushion Stand.

"Paper Feed Pressure in Standard Feed Tray"#p.1-13

!

When printing onto paper larger than 320 

× 432 mm (12

5

/

8

" × 17"), fold all the 

guides.

At this time, set "4.8.2  Stack Guide" 

(

#p.2-25) of the menu setting to "OFF."

fm.book  15 ページ  ２００５年７月２８日　木曜日　午後４時３４分