Tally T8006 User Manual - page 165
Appendix E Network Management
159
contents of the ARP table with arp -a.
On a UNIX workstation, use the command:
The example below shows how to set the IP address of a printer named
PS90d6a1 to 192.168.1.191.
Once the address is set,
ping
the IP address of the printer to confirm the
configuration.
If you receive a message indicating that the network is unreachable, the
Ethernet address of the PC or workstation does not match the IP address
that has attempted to set the network interface. Consult the network
administrator and specify an appropriate IP address.
For a more complete discussion of setting up and using ARP under Unix,
see the ARP manual.
Note:
If the ping command results in a timeout, turn the printer power off
then back on, and retry immediately after printer warm-up.
Setting with RARP
An example of the setting made by RARP is given below. For details, see
the RARP manual.
Add the following line to the Ethernet address table (usually,
etc/ethers
):
Activate the RARP daemon (usually
rarpd -a
).
Reactivate the printer. The IP address is set.
Setting with BOOTP
An example of the setting by BOOTP is given below. For details, see the
BOOTP manual.
Add the following entry to the boot table (usually,
/etc/bootptab
):
arp -s host-name ethernet-address temp
arp -s PS90d6a1 192.168.1.191 temp
ping 192.168.1.191
ethernet-address host-name or IP-address
host-name:ht=hardware-type:vm=vendor-magic:\
:ha=hardware-address:ip=IP-address:\
:sm=subnet-mask:gw=gateway-field