Tally T8006 User Manual - page 37
Chapter 3 Installing Printer Drivers and Utilities
31
5. In the Printer Ports window, select
LPR Port
and then select
New
Port
.
6. In the Add LPR Compatible Printer window, enter the
IP address,
enter
LPT1
for the printer name, and click
OK
.
7. In the Printer Properties window, click
Close
to complete the port
installation.
Configuring the TCP/IP Printer Port in Windows 2000
By default, your printer is installed on LPT1
—
the physical printer port
of your computer. To print over the network, you must now install a
virtual port, and tell Windows to print over the virtual printer port rather
than the physical port.
1. From the
Start
button, select
Settings
and click
Printers
.
2. In the Printers folder, right-click the
Tally T8006
or
Tally T8306
printer you just installed and select
Properties
.
3. In the Printer Properties window, select the
Ports
tab.
4. Click the
Add Port
button to open the Printer Ports window.
5. In the Printer Ports window, select
Standard TCP/IP Port
to start
the Add Standard TCP/IP Printer Port Wizard. Click
Next
to begin
the Wizard.
6. Enter the IP address. This will also be used as the
Port Name
of the
printer. Click
Next
to continue.
7. If the printer was found on the network, the Wizard will display the
network characteristics of the printer. Verify that the settings are cor-
rect and click
Finish
to complete the Add Standard TCP/IP Printer
Port Wizard.
8. Click
Close
to close the Printer Ports window.
9. In the
Tally T8006 Properties or Tally T8306 Properties window, click
Close
to complete the printer port installation.
Configuring Windows to Print on a NetWare Network
The Tally auto-install CD-ROM automatically installs the drivers and
utilities your computer needs to print using NetWare. To print on a
NetWare network, you must have the Novell client installed. If you are
uncertain whether your network settings are correct for printing over the
network, consult your Windows Help or your NetWare operators manual.
Note:
To configure NetWare, you must have administrative authority.
Under 3.x you must log in as supervisor and under 4.1x, you must log in as
Admin. To set bindery, you should log in under bindery mode.