Tally T8006 User Manual - page 90

Tally T8006/T8306 Color Laser Printers User Guide

84

Installation procedureAfter you install additional memory:

1. Turn off the printer.

2. Remove the power cord, and the 

interface cables if they are connected.

3. Using a small Phillips-head screw-

driver, remove the two screws hold-

ing the controller board, and slide the 

controller board out of the printer.

4. Place the controller board on a flat 

surface.

5. Holding the memory module by the 

edges, remove the memory module 

from its protective bag.

6. Hold the memory module so the 

metal edge faces toward the first 

available memory socket and the two 

notches on the metal edge are aligned 

correctly with the socket.

7. Carefully insert the memory module 

into the socket until it is fully seated 

and the retaining clips on both sides 

of the module secure it into place.