Tally T8006 User Manual - page 173
Appendix E Network Management
167
Sample Network Configuration File
A sample parameter list used to configure the network interface is shown
below. The config file parameter names and their default values are listed
on the left side of the parameter list and simplified explanations of the
parameters are listed on the right side.
The sample parameter list shows the default values of a configuration file.
For this example, the Ethernet address is 0:0:87:90:d6:a1, and the factory
set printer name is PS90D6A1. The last six digits of the printer name
(90D6A1) are the six low-order digits of the Ethernet address.
--- General Menu
NODE_ADDR.
: 00 00 87 90 D6 A1
Node address
ROOT_PWD.
: pass
root password
USERS.
:
User authority and printer
access
BASE URL.
: www.Tally.com/printer
Default base URL address
HP_JETADMIN.
: AUTO_SENSE
(AUTO_SENSE, YES, NO)
HP emulation setting
DEF_OUT.
: PR1 (PR1, PR2, PR3,
PR4, PR5, PR6,PR7,
PR8, LPT1)
Internal print output destina-
tion
--- TCP/IP Menu
TCP_ENB.
: YES
Whether the TCP/IP protocol
is valid
INT_ADDR.
: 0 0 0 0
IP address
DEF_ROUT.
: 0 0 0 0
Default router address (0.0.0.0
when no router is supported)
NET_MASK.
: 0 0 0 0
Subnet mask (0.0.0.0 for auto-
matic detection)
PROS_PWD.
: netprinter
Must not be changed
PROS_PRT.
: 35
Must not be changed